Openelec Build for OPI PC and 2 now with HW decoding

Galeots · Published in 2016-3-15 03:21:42

Hi
my install rutorrent- rtorrent error No connection to rTorrent. Check if it is really running. Check $scgi_port and $scgi_host settings in config.php and scgi_port in rTorrent configuration file.
Possibility integration addon for openelec compiler!?

jernej · Published in 2016-3-15 04:01:51

I think I found the problem with stuttering. Please, test this OPiPC image and report: https://mega.nz/#!pUY1UDrI!fyE68 ... 07DslupMdqwmiGknOzU

thc013 · Published in 2016-3-15 04:52:10

stuttering fixed

Demetris · Published in 2016-3-15 05:39:47

Is this image OPi PC compatible?

jernej · Published in 2016-3-15 05:53:41

Yes, I linked PC image. I will upload all images once I get enough confirmations.

hav · Published in 2016-3-15 06:42:43

jernej replied at 2016-3-15 05:53
Yes, I linked PC image. I will upload all images once I get enough confirmations.

It has improved considerably , but it has not disappeared. With a video of about 10 minutes, can be seen

cbm80 · Published in 2016-3-15 14:18:12

I tried it today in the morning with my 2GB card and it didn't start at all. I had no time to dig it deeper but quickly burned previous 0309 version which booted ok. So probably you changed back this booting issue.

jernej · Published in 2016-3-15 14:48:12

Not really. What I changed was removing power button settings from eventlircd. This surprised me very much, but the numbers don't lie. I had always the last U-boot installed all the time.

It seems to me that Allwinners kernel has problems with interrupt handling. Probably that's why they don't use them much. I can hardly wait that mainline kernel will be on pair with this one. For now, it looks promising.

cbm80 · Published in 2016-3-15 14:52:10

jernej replied at 2016-3-15 02:06
As I said, different settings for voltage regulator. In this case, voltage regulator is set to non ...

I'm asking because I wanted to use same image for both of my PC and One boards. I usually replace only script.bin. What else I should replace on the card when I change board to One?

jernej · Published in 2016-3-15 15:03:47

cbm80 replied at 2016-3-15 07:52
I'm asking because I wanted to use same image for both of my PC and One boards. I usually replace ...

The regulator situation in U-Boot for One is not ideal, but I think you are good for now by only changing script.bin.