| 
 | 
 
Hi everybody, 
 
I am trying to get the camera module for the orangePi one to work reliably and with a good framerate. 
 
What works: the camera, with motion software, at 2fps 800x600 resolution. 
What I did: 
I am running armbian http://www.armbian.com/orange-pi-one/ 
According to some posts here it was recommended to use this gc2035 driver https://github.com/avafinger/gc2035 
So I cloned the repo, then setup an ubuntu VM with the armbian sources https://github.com/igorpecovnik/lib, and built the driver. 
To my surprise, the resulting binary gc2035.ko had the same checksum as the one included in the armbian dist... so I guess armbian already uses this enhanced driver. 
 
Then I configured motion like explained here http://www.cnx-software.com/2015 ... -linux-with-motion/ 
 
I get just 2fps. 
 
I then tried to add to /etc/modules soe of the parameters to gc2035, like hres=2 mclk=34. If I add any parameter, after boot up, gc2035 is not loaded. 
If I load it manually, I can load with parameters. So that is one mystery, why it can not load at boot time. 
 
I built mjpeg-streamer, it fails to open the video device. 
 
I also tried to use vidcopy http://192.241.128.247/2016/04/0 ... l2loopback-vidcopy/ 
With most gc2035.ko parameters, vidcopy aborts. With those where it works, the fps is still about 2fps. 
 
I tried pretty much every combination of gc2035.ko parameters, and resolution, using vidcopy or not, and I still get about 2fps. 
 
Anybody has any idea what is wrong here ? 
Anybody has an OPi with the camera module working correctly ? 
 
I am open to all info and comments... 
 
Thanks ! 
 
 |   
 
 
 
 |