[orange pi one] damaged solder pad

aldobrasil

accidentaly i pulled the cable that was soldered to the tvout solderpad. the solderpad delaminated from the board and now i cant solder it back.

by carefully removing the paint i found a very small via besides the solder pad. is it connected to the tv out solder pad on the orange pi one v1.1 ?

the pcb design does not show traces and vias, so i cannot discover this...

if it is connected to the solder pad, i might solder to it the cable and have my one working again.

I need the true pcb layout, not the junk autocad file that does not show traces...

Sod-Almighty

Use a multimeter to check continuity between the points maybe?

chaszim

I think the schemetic is available on the main site, you might be able to route a wire from the last place, the line came from. Time for some micro slobbering a good lite, third eye will help too.