|
|
This post was finally edited by haggis_supper at 2025-8-30 21:52
Does any one have the mounting dimensions for the CM5 and either of the two boards
CM5 Table Base
CM5 Base Board
I've already designed a basic 3d enclosure for the Base board ( 1st draft i'm not happy with it ).
And currently working on the tablet base.
As someone mentioned in other discussions a basic mounting schematic should be available if you want anyone to properly integrate these boards 
I've found the hole positioning for the CM5 as being 33 and 48 between the mount holes.
|
|
Show IP Card
Radar Card
Published in 
Bump Card
Stick Card
Silent card
Open Thread Card
Highlighter card
Jack
Anonimous Post