| 
 | 
 
 This post was finally edited by tkalfaoglu at 2023-7-27 16:24  
 
 
Hi. I'm trying to connect 3 drives to the unit.  
All drives are 1tb in size..  2 drives are self-powered (they have their own power supply), and the third drive is a 2.5 inch drive connected to a USB to sata converter. that drive is not self powered. The system (ubuntu) is installed on one of these self-powered drives. 
 
I have a powered USB 3 hub.. I tried various methods:   
 
1) all three on the USB 3 hub, hub's plug connected to USB 3 of the board (the upper connector on the board). 
2) two of them on the hub, the third on the USB 2 of the board (the lower connector) 
 
In almost every case, they work for a while, then something goes crazy -- a drive is not readable until I power off everything and power it up again -- and do an fsck on the drive. 
Did anyone have any luck with a such setup? Multiple drives on our machines?  
 
Thanks.. |   
 
 
 
 |